Forum Replies Created
-
Posts
-
I have tried it as per my initial comment but the thing is I didnt hear any 2 beeping sounds though all of the lights got lit (so I assumed that was it) so I then toggled the Spin buttons until I have hold and slow spin lit.
Outcome: nothing was lit except for High and Low and the hold and slow spin are lit. Does it tell u something?
i got desperate so i manually put some water in so i could wash our clothes… its washing the clothes now but i want the washer to do the job by itself in pouring the water in .
this sounds promising however my problem is, i have already openned the control panel etc but how would i know which is the lid switch and out of balance switch?
sorry for my ignorance. im just starting to learn 🙂 googled for an image but cant find closest to my wahser
sorry cant wait for updates from the Mod so I did some digging and saw one post saying check the board/panel for any moisture and to my luck the start switch (got some moisture) so i cleaned it up and tried it again and the start button works again!
however, for some reason, another fault came up, as u press start, it would only fill cold water for around 5 seconds then the valve just seems to close and prevent cold water to go inside the washing machine., what did i do wrong?
i only tried the diagnostic steps and the reset thingy.
