Forum Replies Created
-
Posts
-
Re: Bosch sgs5312gb/12 – NOT a pcb problem!
Thanks again. I’ve flushed everything out and it now seems to be working – has just completed a 65 degree intensive wash. Fingers crossed!
If it is/was a PCB fault I think it must be intermittent, because QER has fixed the board once and subsequently checked it over again.
I’ll see what happens over the next few cycles.
John
Re: Bosch sgs5312gb/12 – NOT a pcb problem!
Thanks for your help Penguin.
It’s definitely heating, though I haven’t measured temperature – door gets warm, outlet pipe is hot when pumping and interior of the machine is hot and steamy when the door is opened.
Ran it a couple of times since my last posting. For the first time, quick programme actually completed and finished with heater on for drying. But 65 degree intensive program took about 45 minutes on wash, about the same on rinse – then indicator bar went to “dry” but machine stopped without pumping out water. Had to press reset to pump dry.
John
