[Keyhill]

Re: Machine not filling after fixing not emptying

How do I reset the Eprom or is this one for an engineer?

[Keyhill]

Re: Machine not filling after fixing not emptying

Drained the water using the rear hose and the front filter drain, Removed the pipe from the sensor reattached the pipe. Turned machine on put a jug of water in the drum and closed the door, selected pump out and start, pumped out fine. tried a wash cycle and no water enters detergent tray.
Tried a Rinse cycle and still no water. had some wet towels so tried a spin cycle and this works fine water pumps out and cycle completes as normal.

any way of checking if pressure sensor is working?

[Keyhill]

Re: Machine not filling after fixing not emptying

Thanks for the help.
Followed instructions pumped out fine.
But still doesn’t fill on wash or rinse cycle.
suspect it may be valves and only coincidental they fail at the same time?
This model has only a cold water feed and a dual inlet valve i assume one is to direct water to soap dispenser and the other is direct to drum for rinsing is it likely that both would fail? Any suggestions before I go and buy replacement valves.

[Author]

Posts