[kiwiroy]

Re: AEG Lavamat Turbo L16830 – Which PCB?

Just updating. After a little coaxing, resetting the error code and power cycle, this machine has done two 40degree wash cycles without the drier element. New element on order. Is there a recommendation to replace the gasket for the drier element at the same time? Condition wise it appears fine.

Thanx

[kiwiroy]

Re: AEG Lavamat Turbo L16830 – Which PCB?

Thanx for the advice and prompt reply…

No I didn’t use a megger, only an ohm meter which claims to do max 1Mohm. Sadly it appears it doesn’t get close in solving this 🙁 Anyway, using the proper kit shows 20Mohm and 1.5Mohm for the drier heating elements and infinite for the main washer element. Does this explain the symptoms seem?

Here’s hoping as 60squids much better than 200.

[Author]

Posts