KWIL

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • March 2, 2019 at 5:57 pm in reply to: whirlpool AWZ 7913 LED fault codes #460699
    KWIL
    Participant

    Have now had the back off, all NTC now checked and OK, all wiring is OK, still cannot clear fault LEDs.

    February 28, 2019 at 5:33 pm in reply to: whirlpool AWZ 7913 LED fault codes #460698
    KWIL
    Participant

    Have yet to take the back off, so the thermistors next and then module check. but not today.

    February 28, 2019 at 4:39 pm in reply to: whirlpool AWZ 7913 LED fault codes #460696
    KWIL
    Participant

    OK so far, so what do you suggest is the problem? Humidity unit behind fluff filter is clean and connections are fine up to the Module. Module testing? All connections and cables are OK

    February 28, 2019 at 4:05 pm in reply to: whirlpool AWZ 7913 LED fault codes #460694
    KWIL
    Participant

    Pushing Start does not RESET anything. I presume NTC referred to above is NTC on air duct which mensures13.8K

    February 28, 2019 at 3:30 pm in reply to: whirlpool AWZ 7913 LED fault codes #460692
    KWIL
    Participant

    Yes LED pattern as shown by you. Reset turn dial to bottom (above 6th sense writing), 3 pushes of start and then turned one notch clockwise to “Airing” 3 more pushes,

    February 28, 2019 at 2:46 pm in reply to: whirlpool AWZ 7913 LED fault codes #460689
    KWIL
    Participant

    Yes I tried the Reset (as above) twice. Numbering the LEDs clockwise 1->7, 3 4 5 6 are On and 1 2 7 are flashing

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)