Forum Replies Created
-
Posts
-
No worries, thanks very much for your help. Much appreciated.
With a bit of luck the nuts didn’t come from the washing machine. I’ll give it a spin this evening and see what happens.
Thanks Iadom. I had another look, I was mistaken, they are screws with hex heads, not bolts. The nuts fit them but as I just discovered they don’t tighten fully.
Back to the square one. I can’t see any other place on the motor they would have come from, all I did was replace the brushes.
Would you have any other idea? The way I had them lined up on my bench they should be from the front panel or pump/sump area.
Many thanks Iadom, the nuts fit the motor mounting bolts.
Only thing is there are four bolts and only two nuts.
Would you have any idea if the nuts are usually on the two front bolts or the two back ones, or some other combination?
I could just get two more nuts so each bolt has a nut, but I’m a bit reluctant as there were only two originally.
