Forum Replies Created
-
Posts
-
Re: Hotpoint WM63P several issues
Goatboy wrote:That could be a loose concrete weight, or maybe just your workmanship 🙁 Im very sorry if I insult you,
Despite your aspersions on my abilities… you’re still my hero because indeed the bottom weight was loose and since tightening it up this morning, the machine is back to it’s old self.
Thanks for the useful suggestion.
Re: Hotpoint WM63P several issues
Thanks all for the various points.
Goatboy… Fair comment but I’m pretty sure the new bearings are installed OK. I’ll take a close look at the weights.
The machine is getting a hot fill, so I’ll check to see if it heats during the E program heat cycle, thanks for that.
Pity the diagram isn’t available, it would make things SOOOO much easier. A new board at £85 is out of the question anyway.
Cheers
