[LeaUK]

Re: Hotpoint – Aquarius 800 WM12A, change bearings, difficul

I’m worried that if I strip it for investigation it won’t go back or will leak 🙁

But a vey many thanks to you both for your assistance, cheers.

[LeaUK]

Re: Hotpoint – Aquarius 800 WM12A, change bearings, difficul

Hi Penguin

Ah, the brass bush is integral with the spider/drum support! Makes sense to change it then 🙂

I guess the only concern I’m left with is how to remove and replace the bearings (get them on and off the shaft). Large hammer?

Lea

[LeaUK]

Re: Hotpoint – Aquarius 800 WM12A, change bearings, difficul

Hi Penguin

Many thanks for your advice and such a prompt reply.

I see that you’re recommending a complete spider kit as opposed to just the bearings, is this because of the severe vertical movement I notice? Does this indicate complete bearing failure and more?

One other thing, there’s much mention of the brass bush which could also be damaged, is this included with the spider? Or perhaps it’s integral to the drum?

Thanks also for the tub seal link and tip 🙂

Total cost seems around £35 + delivery so I’m not sure it’s worth the physical torture (I’m assuming this is hammering the bearings off and on?)

Lea

[Author]

Posts