lorde85

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: Ariston Margarita 2000 AL68x PT Problem #175714
    lorde85
    Participant

    Re: Ariston Margarita 2000 AL68x PT Problem

    You’re right, i tested it in my girlfriends washing machine (same model of my client) and it flashes the same way you discribed…tomorrow i’ll change the door lock to see if that’s the problem.

    Thks penguin45

    in reply to: Ariston Margarita 2000 AL68x PT Problem #175712
    lorde85
    Participant

    Re: Ariston Margarita 2000 AL68x PT Problem

    No that’s not it, my clients machine is this one:

    Sorry for the foto but i can’t get a better one.

    Answering your question:

    yes, the knob was going round and round, it flashed n times (can’t remenber), it filled up with few water then it put it way, this is an error, then i made a reset like you said in your post, then nothing changed…

    I looked at the PCB and a transistor had blown up…so i purchased a new PCB and installed it with the old EEPROM…the machine didn’t do the same error…now it flashes 1 flash,2 flash,rapid flash (about 3 times),then light always on, i don’t think this is an error because i took a look to the list of errors that i got and there wasn’t this error…

    So i took a look to the details of the nem PCB and to the olf one…and i noticed that the reference of the microprocessor wasn’t exactlt the same…the old EEPROM fits with this microprocessor?

    Thks again you’re good people 😀

    in reply to: Ariston Margarita 2000 AL68x PT Problem #175710
    lorde85
    Participant

    Re: Ariston Margarita 2000 AL68x PT Problem

    Well the PCB cost 75.00 EUR = 51.3095 GBP.

    Here in Portugal don’t exist much information, however i found a list of errors (the owner of the shop searched among the sellers and gave it to me), and possible causes…but i haven’t the Serial to connect the machine, can you tell me more about it…because in that list i read a part about an Auto-Examination or something like this 🙄

    I’m really stuck in this…i repair washing machines, dryers, refrigerators and so…but i don’t understand much about electroniques and nowadays every little machine as an electronique component, like microprocessors and eeprom’s and so…and i’s really like to learn how to repair this simple things, but here in Portugal there isn’t many ways to get an course or formation in this.

    Many thks in your cooperation 😉

Viewing 3 posts - 1 through 3 (of 3 total)