[Maanse]

Yea so measuring from the pins inside the power connector housing I get no reading at all.

I’ve ordered a new heater now so fingers crossed.

[Maanse]

Pressure chamber appears to be clear. I’m getting no resistance on the heater at all.

So new heater it is then I guess.

[Maanse]

Hi Dave,

Thanks for the help. Unfortunately this hasn’t seemed to help.

The error codes I had were
1 flash – The appliance does not fill with water 2 flashes – the appliance does not drain
3 flashes – the anti flood device is on
4 flashes – malfunction of the water level detection sensor

Initially putting a cup or 2 of hot water allowed the machine to run. Now there are no error codes at all, the cycle completes (I’ve tried all 4 programs) but there is no hot water pumping out and no steam/heat at the end of the cycle.

[Author]

Posts