Forum Replies Created
-
Posts
-
Re: Hoover soft wave error code 11
Yup that was it. Many thanks for the prompt and accurate help. Much appreciated. 😀 😀
Re: Hoover soft wave error code 11
Where on the washer is the NTC probe for drying? I have took the item that looks like a switch on top / front of the cowl going from the dryer fan to the front of the washer checked the connections and cleaned it. This had no effect. Started to follow the cables back to the PCB. Noticed that at the back left hand side there is a cable clamp arrangement that the tape on the outside looked a bit distressed. Took that off and found the red cable from the switch almost apart. Made that off into a terminal block and now giving it a maintenance wash.
So far so good 20 minutes in 😀 . I will let you know if all OK.Cheers.
Re: Hoover soft wave error code 11
Thanks for all the help. I was rather hoping it would be a simple one but doesn’t look like it. 😥 I will have a go and get back to you with the result.
Re: Hoover soft wave error code 11
Thanks for the reply. Where is picture 3? I can’t find it. What you say is correct with the whole cycle taking 15 seconds but it is definately flashing 11 times in that period. I have counted it several times…. One other thing is it was originally starting to not take out the conditioner from the tray. I have cleaned out the compartment and the water injection holes but no effect. It seems to stop quite early in the sequence.
