[marathon]

Re: Whirlpool Dishwasher

Hi Dave ? I’ll give it a quick once over to see if there is anything obvious on the PCB but I have already replaced one ( mentioned earlier) so it might be a new dishwasher. 😕 😕 😕
Regards

[marathon]

Re: Whirlpool Dishwasher

Hi Dave, not the sensor or wiring. Wiring checked between circuit pcb plug and plug for the sensor – good continuity both wires. Also compared sensor with another and resistance the same- but changed it anyway. Fault still the same. You mentioned the timer in your list. Where is that ? Is it on the main PCB in the door ? Also,noticed there is another gismo with a wired connection in the sump. Could this be the problem ? :eeek: :eeek:
Regards

[marathon]

Re: Whirlpool Dishwasher

HI Dave, thanks. Presumably it connects to the main control board in the door? I did have a problem last year with the plastic cover over the board wires failing and the sharp metal of the door cutting a wire and shorting the main pcb. I thought I had covered and protected the wires aginst that happening again. I’ll let you know how I get on. And thanks again for your help with this. 😛
Regards

[marathon]

Re: Whirlpool Dishwasher

Hi Dave, is the ntc thermostat east to get at ? :rolls: Is there an exploded parts diagram anywhere. Appreciate your help.
Regards

[marathon]

Re: Whirlpool Dishwasher

Hi Dave, thanks for the response. There doesn’t seem to be any sequence. It continually flashes and beeps also, until I turn it off. :rolls: :rolls:
Regards

[Author]

Posts