Forum Replies Created
-
Posts
-
It goes straight from fill to drain. Does not seem to wait for a pump. Can hear a bit of sloshing from down low. Managed to crack the pressure sensor that sits on the heater element tube so need one of those anyway. That switch was good though. Need to get a replacement pronto so may cut my losses and sell for parts. Bit annoying given it’s brand new but will be expensive to just fire the parts cannon at it.
Thanks for the response. This is a cheapo washer so no digital display but flashes all 9 lights 4 times and beeps and repeats until you turn it off. Even if there is no pressure switch I assume there must be some sort of water level sender so it knows when it’s full/empty. In the past I tend to find these level senders in the water matrix itself. Any idea where it is on these Candy/Hotpoint machines?
There is a sender towards the rear of the machine on the pipe that the heater element sits within. Could this be a level sensor?
Machine fills to the point the water is level with the bottom of the cavity. No water flows into the cavity itself.
