Forum Replies Created
-
Posts
-
Re: FZA81 Hotpoint FrostFree Freezer Problem
fraggle – thanks but there’s no rubber tube above the drip tray that I can see. Also not sure what you mean about “using a length of cappilary”
Re: FZA81 Hotpoint FrostFree Freezer Problem
cessna – Thanks for your reply.
The dissipator is clean. The issue is that ice blocks the drain plug and fills the bottom drain channel of the freezer before the ice overflows into the bottom part freezing the lowest tray in place.
The high temp light came on last night again and I had to remove ice again.
Previously I have noticed a small amount of condensation/water in the V groove in the seal on top of the door but it stopped. I now think that the door seal isn’t great. However the magnetic strip seals perfectly against the main unit so I wonder if there is a manufacturing fault in the door which is letting air in? Also lately there is a ridge of ice on the top part of the door where it comes close to the top tray, seeming showing air getting in.
So how can this be fixed? Can a new inner door piece be fitted? What options have I got re: engineer call out etc?
Thanks
