[McKenna32]

Apparently I have a 19.5kB upload limit (eh!) so I just posted the pictures on DIYnot instead

https://www.diynot.com/diy/threads/b…p-wear.602693/

[McKenna32]

Thanks for the reply [USER=”4209″]electrofix[/USER] !

electrofix wrote:
lamp failure will msot likely be led driver problem and wont affect machine

So the lamp I believe is incandescent and it still works, just flashes when it shouldn’t, which I imagine is a failure of “smartness” in the “smart lamp module” thing.

electrofix wrote:
you will not get anything from the moisture sensors

What makes you say that? Because it’s broken or because the electrical signals are too subtle? This second one seems unlikely, I can run the wires out of the machine and put a scope on them or probe at the board so don’t think I’m just trying to poke a meter at them with the door open! 🙂

​​​​​​​

electrofix wrote:
looking at pictures of the board, the sensor section seems to have a seperate power supply which may have failed

Interesting observation…will have a further look at this!

Cheers

​​​​​​​Al

[Author]

Posts