Forum Replies Created
-
Posts
-
Well, to be honest I’ve not particularly enjoyed this model so replacing it isn’t the end of the world. Thanks for the help!
https://photos.app.goo.gl/YFUX3JD6KM2CNYyR7
Aha, I think I have found the cause. Water definitely coming out of the tap. But I reckon the initial leak must’ve caused this to blow?
Hi Dave,
Just replaced the old valve, unfortunately the same error. This has made me question if I have the lights correctly. Here’s a link to a video that shows the combination: https://photos.app.goo.gl/3ZtUZZe54vK5AbqG7
Appreciate the help!
Thanks Dave. I have just removed the old valve and ordered a new one. Should be here by the end of the week – Will keep you posted!
Thanks for the reply Dave, sorry for the delay I was without a phone. The hoses look fine and the tap is on. The plumbing was only fully redone in February so it’s all quite new. Failing those things, any other ideas?
current state of affairs:
Light 1 flashes and it beeps for about 5 minutes. Then lights 2 and 3 stay on and the low salt/rinse aid are flashing.
It isn’t pumping out ok but I can’t find a blockage. So I just drained it using a sponge and cleaned it out.
Now this has happened:
When I pressed start it appeared as though nothing happened. Then Light 1 flashed and it beeped for about 5 minutes. Now only lights 2 and 3 are on and the low salt/rinse aid are flashing.It can’t seem to make up it’s mind what’s wrong. Any idea what this new error code might be?
