Forum Replies Created
-
Posts
-
Re: Hotpoint WT960P not working
I’ve checked the display panel and the power board no obvious problems, I’ve also checked the power on point and the water heater, both seem OK.
I can only think it’s the power board at the bottow right hand side, but reluctant to replace unless I know what made it blow, unless it was the silly motor plug mistake in the begining, the bit that’s throwing me is that it started to work OK then stopped, not sure what to try next!
Re: Hotpoint WT960P not working
DDSDDS wrote:if you are sure that all the wires are in the correct place and that all of them are tight then
answer me these questions
when the display goes dead if you go close to it can you still see any lights there
The display is still dark as though it is not even switched on.have you tried another socket
We just tried a different socket and didn’t get any display at all but i think i still heard a single click noise.
When we went back to the original socket and turned it on we heard several popping noises comming from the rear somewhere before we turned it off quickly and haven’t tried to turn it on again.
does the door remain locked while the display is dead or unlock after a few minutes
We could freely open and close the door when it was turned on, ie no lock activated.
if you unplug it and re plug it does it come straight back on or do you have to leave it unplugged for a bit
We did not need to unplug it no, but the LCD parts that made up the numbers/words etc only highlighted on the initial switch on and after that only the backlight on the panel flashed for a moment. And just to confirm none of the dials or buttons have any lights around them at any point.
