[miketr]

Ok, I will do that this afternoon.

From what I can tell from the previous attempt, it can fill and heat but it cannot circulate the water or drain it.

[miketr]

It started the programme and seemed to be going for the cycle.

I never heard it beep to finished so I checked it 3hrs later. The bottom is completely full of water. Doesn’t look like it drained anything.

[miketr]

Thank you Dave.

I got it of but couldn’t see any problems and it spins freely.

After putting it back together I re-ran the test program but it still seems to stop at the same place.

It is weird that the tet program doesn’t seem to finish becasue when you open the door it is showing the pause symbol.

[miketr]

Thanks for your help again.

Any idea how you remove the drain pump?

Do you need to take the front panel off ?

[miketr]

Hi Dave,

Thank you for the help.
I took the front bottom panel off to get to the switch and saw that there was quite a bit of water downthere. I assume this happened when the drainage got blocked. I tried to remove all of the water and then ran the test again. This time it did the drainage test and moved on to the fill test. I think it then got as far as the second drainage test before failing. I assume it failed because I left it 40 minutes and it seemed to have stopped doing anything. When I opened the door there were no fault codes but it was full of water again.

I assume this means the drainage pump isn’t working?

[Author]

Posts