mnc123

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: Smeg SE398X Oven keeps switching off! #201378
    mnc123
    Participant

    Re: Smeg SE398X Oven keeps switching off!

    Hi,

    Look at my problem a few posts down…. Sounds similar to me!

    in reply to: Indesit FORNO 20K.C IX GB – Cutting out when hot #190924
    mnc123
    Participant

    Re: Indesit FORNO 20K.C IX GB – Cutting out when hot

    Hi,

    Sorry for the delay in closing this query but the oven is now fixed. :rolls:
    I took it into work over xmas and gave it a good clean. I found that the thermal cutout was absolutely caked in baked on grease etc and cleaned it up. This appears to have cured the problem but I obtained a new one from the very helpful peeps on here (£9 inc del) and replaced it anyway (5 Mins)

    Missus is now happy and doesn’t blame the oven for everything!, cheaper than new oven @ £250

    mnc123

    in reply to: Indesit FORNO 20K.C IX GB – Cutting out when hot #190922
    mnc123
    Participant

    Re: Indesit FORNO 20K.C IX GB – Cutting out when hot

    OK, an update to the problem. The oven died again last night when set to 200 degrees, the oven thermometer that I bought showed just below 200 degrees so I assume the thermostat is not at fault? I will take it out and put it on the bench and see if I can get it to go faulty to test the ventilation theory……

    Does anyone know where the thermal cutout is on this oven and would I just have to look at the ventilation around that area or the oven as a whole? – It is in a standard 600mm unit with cupboards either side and a hob above, the hob is usually off when the fault occurs and they are fed from different supplies

    Martin

    in reply to: Indesit FORNO 20K.C IX GB – Cutting out when hot #190921
    mnc123
    Participant

    Re: Indesit FORNO 20K.C IX GB – Cutting out when hot

    Barneyb,

    Thanks for the advice I will probably end up taking it to work and putting it on a bench – Should test the ventilation theory and I have a thermometer on order – I will report back – Thanks again

    Martin

Viewing 4 posts - 1 through 4 (of 4 total)