[mrsrockguru]

Re: Indesit IWDC6125 – drain issue

how would one reset the pressure switch?

also reprogramming or reset the pcb how do I go about that?

[mrsrockguru]

Re: Indesit IWDC6125 – drain issue

ok, if the main pcb has been damaged why would it still work on a rinse cycle and fill the drum and go all the way to the drain then stop. It will actually pump out for a few seconds before it errors. So it might be the pressure switch which has gone screwy.

Aly

[mrsrockguru]

Re: Indesit IWDC6125 – drain issue

Same issue as described, all lights flashing. Pulled it and resistance was showing as 232ohms (watched the video by e-spares on how to replace the pump – vid titled – all lights flashing and E11 error) purchased replacement and fitted it while the machine was flat on its side. ran a test on empty machine, starts pumping out the stops after a few seconds, will do it again after I have turned off the machine and back on again.

[Author]

Posts