[mtullock]

Re: Beko WMB51021W not working

Got a new mobo today, machine running fine. Thanks for all the advice

[mtullock]

Re: Beko WMB51021W not working

Just an update. Changed the lock, the brushes and checked the pump. Have looked atvthe pcb and there is a chip with a hole in it……connected to the door lock pin…..may well be the cause lol

[mtullock]

Re: Beko WMB51021W not working

Thanks Dave. Have taken pump apart and it is clear and seems to turn ok. Might have to get a pro in as I am fed up of throwing money at it. I assume holding start and turning the dial to cotton puts this into a diagnostic? I can’t seem to get it to do anything else once I have done this (no drum tests etc). The other strange thing is that the water inlet hose seems to hiss with air when I disconnect. I have tested the pipe and water is certainly flowing through the pipe

[mtullock]

Re: Beko WMB51021W not working

Have watched endless vids but non match the wierd machine have. Here is my vid https://youtu.be/8uUYah9rMWc

Cheers

[mtullock]

Re: Beko WMB51021W not working

Thanks for the suggestion but no luck sadly. I did take a video of the problem if that helps anyone. I think even if i could figure out how to put the thing into diagnostic mode at least I could eliminate some possibilities. The filter was full but cleared that, unless it has made the pump faulty.

[mtullock]

Re: Beko WMB51021W not working

Hi Dave,
It was the electronic lock

cheers

[Author]

Posts