[NeilCann]

Re: Zanussi ZDT41 thermostat replacement

thanks Dave

Sounds like it could be any number of things!!

I have tried opening the diswasher and seems to be as much water as expected.
If it was the thermostat is it any easy swap and where is it? cant find any info anywhere, I assume its will be under the machine and obviously in the water intake somewhere.
I use NTC`s in my job and these are all resetable but looking at them on parts suppier sites these are not, would like to measure the resistance when it goes wrong.
Seems to be if we switch the machine off at the wall for a while and try again the machine works fine for a while but always returns, very frustrating.

[NeilCann]

Re: Zanussi ZDT41 thermostat replacement

thanks Electrofix.

The only reason I assumed the thermostat as I have read elsewhere about them getting to temp on a cycle and either going closed/open circuit but getting stuck in that state and hence diswasher always assuming the water is at temp.

How do I check water level and add a bit?

I would have thought a broken wire or heater would not be intermittant either, I have had a look over the control pcb and all looks good no dry joints etc.

thanks

[Author]

Posts