Forum Replies Created
-
Posts
-
Re: F&P GW 700 B-U Washing Machine
Hi Guys
Sorry for the late reply, have been away. Kiwi was right on the money, it was the RPS. Thans to him and Penguin – fantastic site guys! 😆
Re: F&P GW 700 B-U Washing Machine
My email address is neil@nco.com.au
Hi Again Penguin
Just checking I am giving you the right ldiagnostic Led’s. It is the Long Wash, Final Rinse & Spin leds that remain constantly lit when the beeping starts. Total of 8 leds across the top of this model so if Spin=1, Final Rinse=2 & Long Wash= 8 the error code is 11?
Thnks again for all your help, this is such a great site!
Re: F&P GW 700 B-U Washing Machine
Thanks Penguine!
I’ve read quite a few including the one about the rotor sensor, presume its down near the smartdrive? Don’t think it is the out of balance switch, seams to be working fine. Replaced the two valve inlet units already and a new lid. Had to Adjust the lid reed switch in the controller just a bees dick because it wasn’t engaging properly with the lid closed. It is now.
The fill problem is intermitent, persistantly trying to run the machine will eventually get it to work and often it will then run a number of loads. Going back to it the following day and it will do it again. Does this tell you anything that could narrow the fault down a little?
Brgds,
Neilo
