[Nelly54]

Re: Bosch SGS43E02 poor cleaning performance – I read the FA

Sorry. Ive managed to do it since my last posting and cleaned all the relevant bits and bobs – urggh ! However since connecting everything back together and starting a cycle to test there doesn’t appear to be a lot happening, i.e the machines not even filling up with water now (Yes the water is turned on !) Any suggestions? Oh yeah and its the same model.

Cheers

[Nelly54]

Sorry I’m referring to the problem in the forum above.

[Nelly54]

Re: Bosch SGS43E02 poor cleaning performance – I read the FA

I have the same problem but can’t suss out how to get the top off in order to get the side panel off. Any help to get me started please……

[Nelly54]

Re: Whirlpool AWM 8123/S Door Lock

Washing machine up and running! I am very proud person tonight ! Thank you loads for helping me out. Dishwasher problem next….. 😀

[Nelly54]

Re: Whirlpool AWM 8123/S Door Lock

Done it!! Am only feeble female after all ! Will let you know how I get on. Cheers.

[Nelly54]

Re: Whirlpool AWM 8123/S Door Lock

Yep did that before I replaced the first carbon brush and removed the one bolt. But it only swings clockwise. On the left hand side of the motor it has two stainless steel attachments (top and bottom) which just seems to allow it to swing around. There doesn’t appear to be any other screws etc to remove and I’ve tried lifting it but that doesn’t seem to work either. I’ve had a look for a tech manual online too for some indication of how to remove the motor but no luck there.

Am I being a homer simpson ?

[Nelly54]

Re: Whirlpool AWM 8123/S Door Lock

Hey only me again ! Carbon brushes have arrived today. I’ve managed to replace the one on the right of the motor but can’t get to the left one. You said that I should remove the motor but I can’t for the life of me see how to do it – I’ve removed the big screw which allows me to swing it clockwise slightly but otherwise I’m stumped!

The left carbon brush is at such an awkward angle that I can’t see how else I would get to it without removing the motor? 😕

Any help much appreciated.
Cheers

[Nelly54]

The brushes are well worn down! So am going to order another pair and see if this fixes the problem. Many many thanks for your help.

[Nelly54]

Thanks for that. Am going to check now.

[Nelly54]

Thanks for that. Will check and let you know. If it is the brushes are they easy to replace?

[Author]

Posts