[Octopus1]

Re: IDL40 Flashing1 and 3

Hi guys you may find if its not the filters that are the cause then it certainly will be the pressure release valve pipe. This is located on the right hand side at the machine at the bottom. Just remove the side panel (there are about ten screws to remove with a Phillips screwdriver). You will then see a round unit with a black pipe of about 12-15mm diameter. Pull it off the unit and give it a good hard blow, if it’s blocked you should be able to clear it easily. The blockage will blow back into the filter reservoir and I would recommend sucking it out with a wet and dry vac to be sure. Then refill the reservoir with a little water before reassembling and running the machine. I have done his myself after watching a repair man do it last year and it works.

[Author]

Posts