Oh-no

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)

Author

Posts
September 23, 2021 at 11:35 am in reply to: AEG T65270AC error = EH0 after 2nd or more cycles #464263

Oh-no
Participant

I had a go at melting the large solder joints on back, in case any micro cracks. Error message has turned from EH0 to EHE now. Is that an improvement and helps narrows down where to concentrate on next?

March 14, 2021 at 7:34 pm in reply to: AEG T65270AC error = EH0 after 2nd or more cycles #464254

Oh-no
Participant

electrofix wrote:what is the full PNC number of your dryer ?

Dave

916 097 679 00

March 14, 2021 at 4:58 pm in reply to: AEG T65270AC error = EH0 after 2nd or more cycles #464252

Oh-no
Participant

I had high hopes for repairing my dryer, after I spotted a damaged solder contact. But unfortunately it didn’t fix the problem.

It was one of the long metal wires, seen on sigurdur’s picture, on bottom edge and right of centre.

My question is, if I ordered a Not Configured Electronic EDR1 direct from AEG, then how you do configure it?
https://shop.aeg.co.uk/laundry/tumble-dryers/electronics/not-configured-electronic-edr1/p/1366100715

https://imgur.com/a/JfSzCAo
Author

Posts

Viewing 3 posts - 1 through 3 (of 3 total)