[ozmale]

Re: F&P 501 Fault – Spin Light On

Hi, thanks for the responses

Cannot get into diagnostic mode as no buttons will respond to being pressed. We can only turn off and on from the wall switch and not on the washing machine, does this mean the control pannel is faulty?

Have checked for water/dampness in the top sactions of the machine, power off and plug out of course.

Any other suggestions would be appreciated. If it is the control panel (is this also the computer referred to by Pengiun 45?) is it a simple task to replace. I understand here in Australia you can only get a reconditioned changeover unti as new replacements are not sold. They are approximately A$165.

Thanks and regards

[ozmale]

Re: F&P 501 Fault – Spin Light On

Penguin45, thanks for the quick response.

No beep, just a light blinking in the spin position on the display. Sounds terminal?

The machine was functioning Okay until one day water was filled into the machine accidentally before the machine was turned on. When the power was turned on the spin light came on.

Had to empty water but the problem remained after water was removed. It dosen’t appear to matter wat button or combination of buttons are pressed the light remains blinking. Is there a master “reset” button or sequence?

Regards

[Author]

Posts