Forum Replies Created
-
Posts
-
Re: Blomberg WM 1301BB No Power Light
Been away but now back.
The prog is not working as indicated on the dial ! On normal spits out the water as soon as it fills up twice. Then takes the water again goes through ok but ends the cycle in about 15 minutes incl spin, rather than 59 min it used to take.
Any clues folks ?
Thanks.Re: Blomberg WM 1301BB No Power Light
Lock seemed to be the culprit. Atleast the WM has got some life now. Does the prog control dial knob slide in only one fixed or it will slide in any position. Normal cotton position is now spin position ! Do you think I have the dial in wrong position ?
Now I will go and tide up the soldered wiring on the module’s burnt track .
Any news about tech manual please.Re: Blomberg WM 1301BB No Power Light
Good enough explanation for me, thanks.
I have some practical electronic & electrical knowledge, can interpret circuit diag, but will be careful. Any idea how to get tech manual.
Still waiting for the spares.
Regards.Re: Blomberg WM 1301BB No Power Light
It’s just I want to order only the faulty parts. The diag on the switch is not clear to me. 1N & 3L is clear but 2C ? Is it just swtiched Live ? Helo_75
I sent an email to you re manual this after your suggestion about the deal for the lock and tech manual but you have not replied about it!
Thanks.Re: Blomberg WM 1301BB No Power Light
Have placed the order for the Lock but my brain won’t stop testing. There is AC mains on the lock on terminal 1 & 2 and when the lock (switch) is closed the 3rd terminal does not receive the Ac mains. So can I say the lock is faulty ?
Park.Re: Blomberg WM 1301BB No Power Light
Hello_75,
Need the lock and tech manual for the engineers. I don’t want to go via google payment system but use direct CC online.
As said the tracks are ok now, inspected the lock is clean. Switched on the WM but still dead.
Spoke to the Whitegoods guy sent an email to them, waiting.
Park.Re: Blomberg WM 1301BB No Power Light
SORRY. I meant not to take many chances.
It’s that I will try NOT to take too many chances with module and order the lock. I am quite enjoying this realy with your help and my electronic knowledge is coming back. Do you know where I can buy tech manual for this WM. But surely I will order the lock as I can use it now or in future.
Thanks again.Re: Blomberg WM 1301BB No Power Light
On checking with mag glass and meter the 2 tracks did not look good, so I have soldered them with the fine sleeved wire. The locks look crystal clear and there is no rust or trace of water, however I will now check for the loose materials and rattle it, as suggested. Do you think I can then connect the module and lock to its place and switch ON WM. The lock at the moment is in open position. Is their anything else electonically I can measure (like resistance) or isolate any connection before switching it on. It’s that I will try to take too many chances with module and order the lock. I will send you the result within half an hour.
Thanks.Re: Blomberg WM 1301BB No Power Light
You are right its not a bad WM so I will find out more to fix it with help from you guys and enlighten myself. The lock shows no sign of burn. What is the best way to get it out to inspect it ? I don’t mind replacing the lock or pcb if I can be sure they are faulty. It is amazing the machine is dead just because of faulty lock. I will have a go at lock and controller pcb tomorrow and order the lock to start with. I want to do little for the environment, not scrap it unless I have to. Is their a TECHNICAL manual I can buy ?
Thanks for your help.Re: Blomberg WM 1301BB No Power Light
Why good night. You mean its expensive ? OR not worth to repair ?
Park.
