PaulSkip

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • PaulSkip
    Participant

    Thanks for this great advice – the wife will be pleased, too!

    in reply to: remove drum paddles from washing machine: Zanussi TLE 1116 W #472449
    PaulSkip
    Participant

    Hi Dave, thanks for such a speedy reply.
    The paddles remain in perfect working order (after many years), but are getting pretty full of wash sludge – and the wife has asked that they be cleaned.
    If it isn’t possible to remove the side paddles non-destructively, then I will look for a way of cleaning them in situ, such as by plugging their drum-facing holes and pouring into them a very hot cleaning mixture from the outside of the drum.
    What do you think?

    in reply to: Bosch SMS6092 w Aqua-Stop programmes stop intermittently #454296
    PaulSkip
    Participant

    Re: Bosch SMS6092 w Aqua-Stop programmes stop intermittently

    Thanks, Dave. I respect your observation that the inlet valve is suspect, and I will focus on that. First, though,
    1. Your linked-to 091058 Aqua Stop doesn’t list SMS6092 (in fact no model beginning SMS6…). Can you reassure me on that?
    2. Even if 091058 is compatible, would the generic Aqua Stop suffice as replacement? https://shop.ukwhitegoods.co.uk/hs81591 … fill-valve
    3. Sometimes the cycle stops AFTER filling. Wouldn’t that have to be caused by a separate fault? Note that, in this case – see above, the machine resumed after being powered off for tens of minutes.
    4. Finally, how best to check if the valve is energised when the fault occurs?

    Thanks,
    Paul

    in reply to: Bosch SMS6092 w Aqua-Stop programmes stop intermittently #454294
    PaulSkip
    Participant

    Re: Bosch SMS6092 w Aqua-Stop programmes stop intermittently

    This time, on the Quick wash, it stopped after the first rinse fill: opening and firmly closing the door restarted it.
    Now it has stopped again after the first rinse drain. Opening & closing the door doesn’t work, nor does switching off & on.
    Any suggestions, please?

Viewing 4 posts - 1 through 4 (of 4 total)