Forum Replies Created
-
Posts
-
It’s ALIVE!!! Received the uit back today Installed and all working as far as we can tell.
Many thanks for your help. It’s be invaluable..OK. So my friend has recieved the parts and the board. Removed the resistor and it fell to bits!! 😮 I noticed in the photo it seems to have a big crack on it!! Anyway it’s in the post tonight so will report back once fitted!!
Many thanks. I might send the board and bits to a friend who is better at desoldering and resoldering than me…. I’l report back when done.
Hi OK Have setup MMeter as shown in https://1drv.ms/u/s!AgTs2fMh_4oJgoo_OC0yhZYmRJk6ig?e=SnjubV
When probes touch display drops from 1 to 0.02 – which i udnerstand is the resistance in the leads….
When placed either side of the green resistor it stays at 1.
So if i understand correctly this is possible culptrit???Wow. Right!! Is this a common fault?? My neighbour was an electrician and has the multmeter so i’ll speak to him in the next few days. Many thanks
Ok got into the control box and can’t see anything immediately obvious. Unfortunately can’t seem to upload photos bigger that 19kb which makes my photos too small to see anything. There is a black plastic component with copper wire wrapped aroud it and one leg appears to have no solder when you flip the board over. It also smelt like hot metal when i first removed the baord even though DW has been lef with no power for two weeks….
