Forum Replies Created
-
Posts
-
Re: Beko DVC6631 – Grill won’t work. Have done element.
Yes – note to self – buy a multimeter!
Replaced the thermal link and all working as intended now. Thanks for input helo_75! I DID talk to myself too..
😀
(Slopes off to deal with frizzy hair and shakes…..) only joking!Re: Beko DVC6631 – Grill won’t work. Have done element.
OK – it’s deffo the second thermal link. I bridged it temporarily and it worked. The link has no readable identification on it – looks like it did at some point….. 🙁 It has a red marker on the end – does anyone know if this indicates the blow temperature? Anyone know what temperature one should be fitted? Maplins carry stock…….. 😀
EDIT had a look at the other one, it has the same red mark – and a faily legible 144c at the bottom. I presume this means 144 degrees celcius?
Re: Beko DVC6631 – Grill won’t work. Have done element.
Thanks – found the thermal link (on white wire running from the mains inlet block up over the ovens towards the control panel) clipped to the bottom oven back – it is live OK on both sides. There is another one on a grey wire which comes from the bottom oven element (which works…) then goes up and over presumably to the control panel too. It is live on the element side but dead on the other side off the link – tried again (yes carefully) with the rings and both ovens turned to on – still dead on one side. Would this be the culprit and are they obtainable?
Thanks for your time reading this people!Re: Beko DVC6631 – Grill won’t work. Have done element.
OK, I have checked the terminal block – no wires off that I can see – any further suggestions folks? Light doesn’t work either, so I assume the whole circuit is not getting power – I swapped the main oven and top oven bulbs to check the bulb is OK, which it is. As I said before – the main oven and hob both work fine.
