Forum Replies Created
-
Posts
-
Re: fisher & paykel dish drawer
Help! Help!
I did as instructed earlier, and all went well. I was thrilled, but pride come before a fall and I come again to seek enlightenment.
I ran through the instructions and popped everything back together. As planned no nasty beeping and I put the bottom unit on to a 12 minute cycle. I let it run to the end and no issues.
I proceeded to repeat with the top unit. Sadly, about a minute or two into the cycle water started pouring out of the RHF corner. I opened the drawer and found the top edge of the unit to be very wet on the RHS. The LHS was much dryer. I have removed the upper unit and the inside of the chassis is soaking, but only on the RHS. It appears that the lid or top is not closing properly on that side. (At this stage both units were empty, so no chance of a large object holding the lid up and preventing a seal.)
Any suggestions?
