Forum Replies Created
-
Posts
-
I would have thought that the software would be in the control module. Is there software in the power module as well? If that is the case, how do I source a compatible replacement?
Thanks
Peter
Hi Dave,
The numbers that I am looking at are on the plastic case of the power module:
EPG60613
9000683387These are exactly the same as those on the replacement.
Thanks
Peter
I’ve now replaced the power module and there is life!
However, there are still issues. The programmes seem to be taking at least twice the length of time that they are supposed to, the red light beneath the right hand edge of the door doesn’t show, the intensive and pre-rinse programmes don’t work (press the button and nothing happens) and the last two items in the menu (P:01 and I:01) don’t appear when you cycle through the options.
I’m thinking that the failure of the power module has cause some corruption of the programmes? Is there a way of resetting the control module to fix these issues?
This is the original control module – I sent the replacement back when it didn’t make any difference.
Thanks for any further advice.
Peter
Found the power model and there’s a component that has died on it – nice burn mark on the plastic case over it. I’ll consult QER for a repair. Thanks, Peter
It was the operating module that I tried. Where on the machine is the power module and do UKwhitegoods sell a replacement – couldn’t find it on the website?
Thanks
Peter
Replacement main board didn’t make any difference.
Is there anything else on the mains side – an internal fuse / power supply that could be preventing the controller from getting its supply?Unplugged the cable where it plugs into the appliance, as suggested and also checked the lead for continuity – all fine. When I plugged it back in again there was no change – no display and nothing happened when “on” button pressed. So, is it just a case of getting a new main board to see if that gets it working again?
Thanks
Peter
