[plwsm]

Re: Liebherr 3056 Power board resistor

Dave,
It was a 100 ohm fusible resistor after all. I changed this and the failed capacitor and the board (and fridge) are now working fine. The board uses a NCP1051C switching regulator in the power supply and this was still ok.
I understand the importance of using a fusible resistor here for safety reasons as these are guaranteed to fail open circuit when overloaded.
Thanks again for your help.

Phil

[plwsm]

Re: Liebherr 3056 Power board resistor

Thanks Dave. I agree that 100 ohms looks most likely, but I am still a bit apprehensive
since the “brown” third band doesn’t look the same brown as on the first band. I was hoping that someone could confirm either way.
Thanks again for your reply.

Phil

[Author]

Posts