[Puppydogpals]

electrofix wrote: first find the pressure sw and make sure the pipe to it are not blocked

Dave

Did not have a chance to look at it until the other day

I put it on so it would fill and drain the water so I could open it up, it filled and started to wash, must of been an air lock in the pressure switch that cleared it self over the past month.

Happy days, used it about 5 times now no issues working as it should.

Thanks

[Puppydogpals]

electrofix wrote:how long does it take to fill

the machine has a pressure sw and may have a water flow sensor to know how much water is going in

you need to check
1 sufficient water is coming in
2 the pressure switch is activating

all this has to happen within a given time to avoid the error

Dave

It takes about 20 seconds to flash E1 after it starts to fill. As soon as if flashed E1 I turned it off and opened door and the bottom of the dishwasher was full of water to where it should be.

So it it is filling to a sufficient level and at acceptable time rate. If I remove the lower sprinker arm it has water in the pipe and none when drained so water is making its way around the pipe system and I have no pipe blockages.

How can I check if the pressure switch is working/ not stuck

Could a faulty water circulation motor the large pump after the drainage pump that sends water to the arms cause this error.

Or is this error just associated to water filling into base and sump??

Thanks

[Author]

Posts