Forum Replies Created
-
Posts
-
Re: Beko CDA648FS/1 Frost Free Fridge Freezer-Fridge is Froz
quaver
re beko CDA648FS/1 Fridge Freezer,
Thanks to David Sussman ( post march 14 2015 ) thank you for displaying your link, showing the photo of the cut out insulation and sensor 4394720185 at the back of the fridge (below the PC cover).
This was all the info I required. I cut a rectangular hole, removing a thin layer of insulation and then cutting in about 50mm to sensor.
I also pierced a hole with screwdriver up into PC Cavity as cable is short, fed new sensor cable through hole and cut old sensor cable 2″ from PC plug to solder new sensor cable to these tails, After inserting new sensor in holding tube, I filled hole with Expanding Foam pressed thin layer of previousley cut insulation over Hole and held in place to set.
Thanks again
quaver.Re: Beko CDA648FS/1 Frost Free Fridge Freezer-Fridge is Froz
Re-Beko CDA648FS/1 Frost Free Fridge Freezer!
Fridge freezing up and fan running all the time.
jskelton555 (Sept 11th 2014) suggested changing evaporator sensor which sits in a tube on back wall, 200mm down from top, 200mm from left side and 50mm deep. Is this standing at back of Fridge/Freezer?
ie 200mm from left top and 200mm down from top. As I can see two thermisters when I take the panel in the freezer covering the evaporator off?Please help.
