[r3hutch]

Re: Fisher & Paykel Smart Drive 053

The new display panel that I installed to fix the original problem was faulty. Silly me, I did not expect a new part to have faults :rolls:

After I could not diagnose the problems, I called a technician who identified it. So it only cost me $122 to find out that I had purchased a faulty part.

Oh well, at least the part was replaced under warranty and the machine is now working and with no diagnostic numbers shown.

Thanks very much for your help,
Robert

[r3hutch]

Re: Fisher & Paykel Smart Drive 053

ok found sticky on error codes.

When holding down Temp Low button and Power button, I did not get two beeps. Instead after a couple of seconds, the water level High and the water level Low lights lit up.

I then toggled the spin speed to Slow and Hold but there were no lights on the top of the panel.

Any help would be appreciated.

r3hutch

[r3hutch]

Re: Fisher & Paykel Smart Drive 053

I have tried all the advice in the instructino manual. Was this the Sticky that you were refering to?

R3hutch

[Author]

Posts