Forum Replies Created
-
Posts
-
Re: AEG Favorit 40660 – Unable to fill
Seamy,
Thanks for the reply. I had a look at the pressure switch and it seems there was a bit of dirt in there. I have cleared the pipe and the switch is working when I suck and blow it. However I may have got the wires mixed up. I assume it doesn’t matter which side of the switch either of the main wires are attached to given that it is a switch. However there is a secondary (Black) Wire that goes to the PCB which I assume connects to the main wire from the heather element?
I have tested the heater element and it does it is faulty. I thinka new machine is the way forward. 5 years with a family of four is plenty for these machines now a days.
Will probably go with the Bosch SGS 57A02GB and take 5yr warrenty for £80!
Any value for the AEG as part on ebay or simply take it to the dump?
ta – robJust had a small thought – Could replace the pressure switch and heating element kit. What is teh difference between “50290104004 Manifold Kit” and “50277796004 Element” They seem to both contain a heating element but teh kit is cheaper! Do you know if Whitegoods sell a suitable pressure switch?
Say £60, could repair the machine for a while again, albeit teh PCB will no doubt go next!!
