[robrat]

Re: Zanussi Jetstream Excel 1250 Wont revolve

Motor runs freely, there is a brown magnet which is attached to a nylon screw type assembly which in turn screws in to the end of the shaft. S, all seems to be as intended.

[robrat]

Re: Zanussi Jetstream Excel 1250 Wont revolve

Thamks guys. My motor is a SOLE. I take it that means mine will not suffer from the Tacho problem?

Any other ideas on what might cause the problem?

[robrat]

Re: Zanussi Jetstream Excel 1250 Wont revolve

Thanks for te suggestion. Have taken that assembly apart, there are no screws, it just pushes together and also is just pushed into it’s recess. Perhaps it’s been modified since rich. I can see that there are lot of contacts in there such that might be used to measure the speed of the shaft turning inside it and 2 wires coming away to the connector block at the side of the motor

[robrat]

Re: Zanussi Jetstream Excel 1250 Wont revolve

Thanks for your responses.

Can’t see anything obviously wrong with the motor. Is the tacho coil the circular component at the rear?

Is it worth getting the motor tested?

Again, Thanks.

[Author]

Posts