Forum Replies Created
-
Posts
-
Re: GW703-U
No I shall amend that – it is still playing up. Is it possible that the wrong valve was replaced recently bcs since then it feels as though it has been filling not as quickly as in the past.
As best as i could follow the sequence for the diagnostic it is either 123, 43 or 83meir
Re: F&P 703 Will not spin at high speed (medium speed on
Thank you Mr Penguin. this forum is a wonderful resource and thanks to all who offer their assistance.
Re: F&P 703 Will not spin at high speed (medium speed on
I decided to fiddle a little and discovered that the out of balance switch is no longer seated correctly. the two pins that run through the body of that switch are broken at their base where they connect to the base on which the switch is seated. i have not yet decided how it might be best to permanently fix that [all suggestions welcome] but after having made a temp fix it seems to be running perfectly.
Would it be advisable to spray the circuit boards and switches with Inox [http://www.inox-mx3.com]Re: F&P 703 Will not spin at high speed (medium speed on
Actually I am not so sure I can trust my ear on this one, it looks like Mr Penguin is right 😆 . I just ran a small load, set the spin to min and as it ran modified the spin speen upwards and it seemed to go OK. Is there no way to determine if it is in fact spinning as it should?
Re: F&P 703 Will not spin at high speed (medium speed on
No Sir Mr Penguin. On empty, and it appears to be sitting with the bowl slightly forward and centred, it does not have that take off sound pitch I used to hear in the past.
Re: F&P 703 Will not spin at high speed (medium speed on
Crickey. I’ve just had the same problem with our 703. Is there no diagnostic code to indicate that in fact it is nor spinning at max? I was first alerted to this by the sound pitch.
How can I access the technical and reapair manuals for the 703?
