[SandsofEss]

Re: BOSCH – SRV43M03GB dishwasher, new but not working.

Thanks Martin,

That’s settled then. The dishwasher was already on its last legs (well leg actually, the two front ones are missing for some reason). Time to begrudgingly buy a new one.

I really appreciate your time and expert advice – if it was down to me I’d have held out vain hope for far too long in order to avoid the expense.

All the best.

[SandsofEss]

Re: BOSCH – SRV43M03GB dishwasher, new but not working.

Thanks Martin,

I’m getting up close and personal to the motor, but I can’t see any way to spin it.

Attached is a picture of the view I have of the end frame, am I missing something obvious?

I’ve also attached a couple of pics from other angles in case that helps..!

[SandsofEss]

Re: BOSCH – SRV43M03GB dishwasher, new but not working.

Thanks for replying Martin.

How do I access the rotors to spin them?

I’m convinced that this is where the problem is as the DW fills and drains but doesn’t run on any cycle. It makes clicking noises as though it’s trying to engage the circulation pump, and the pump housing gets very hot to the touch after a little while, as though power is getting to it, but it makes no noise other than a very low hum.

The motor housing has a chalky/limescale build-up on it, and the dishwasher was out of action for five weeks, so I suspect it’s just welded it stiff.

[SandsofEss]

Re: BOSCH – SRV43M03GB dishwasher, new but not working.

Hello,

Sorry to breach netiquette by reviving an old thread, but I have the same issue with the same model, so I thought it’d be acceptable.

If either of you chaps are still around, I’d be very grateful if you could let me know how to access the rotor blades on the circulation pump to free them up.

I have removed the right panel, but cannot see how to reach the rotor. I’m reluctant to poke around too much without an exploded view diagram or an expert’s advice.

Thanks a lot for reading.

[Author]

Posts