[scottjoseph72]

Re: Hotpoint wma33 tacho

Unit tested with new tacho and will now cycle normally. However I cannot see motor going to full spin and full programme does not complete. Time to scrap this i think.

[scottjoseph72]

Re: Hotpoint wma33 tacho

Hi yes brushes good and motor spins for a few seconds in diagnostic so I know the motor is capable of running.The new tacho coil definitely showing variations in resistance as opposed to the suspect one. Will fit in morning and see how machine performs.
Thanks for input its much appreciated.

[scottjoseph72]

Re: Hotpoint wma33 tacho

Its FHP motor – the magnet was still secure but having ran diagnostics I found no motor movement detected so had a look at tacho and resistance wasnt varying. Ive changed tacho coil now and resistance is varying as you turn. Ive yet to try on machine but stands to reason that this should solve it.

[scottjoseph72]

Re: Hotpoint wma33 tacho

thank you – I have managed to get it off however plate a bit bent. Would I be correct in saying the ohms are supposed to vary as you turn the shaft. I have a steady 85 ohms approx as I turn shaft.

[scottjoseph72]

Re: wm62 not heating

Ok thanks – Is the element fed directly from PCB ( ie faulty relay ).
I can hear pressure switch clicking so dont think thats related and machine cycles normally otherwise – runs through full program.
I shall trace wiring back in morning

[scottjoseph72]

Re: LG WM-1295FHB Bouncing at start of spin cycle

thanks Martin. Will try other loads

[Author]

Posts