[shagmeister]

Re: Dyson CR01 Contra not Contra’ing?

You say look for a ‘control panel with the “VxxxS”‘, do you mean the control board (internal) or the control panel on the front of the machine? Cheers, you have been very helpful

[shagmeister]

Re: Dyson CR01 Contra not Contra’ing?

I havent had chance to get the diagnostic info as of yet, and today is the cardiff beer festival……….. so best i dont touch electrics! The gearbox is dropping into contra mode, the drum starts to drive, clunks as the gearbos drops into the contra mode, but the increase in torque is then stalling the motors. I was thinking that one motor had dropped out decreasing the torque. Is it a do able job to strip the drum to check for corrosion. If it is corroded is there anything i can do to it anyway?

[shagmeister]

Re: Dyson CR01 Contra not Contra’ing?

The Ramp motor and ramp assy is working satis, and the clutch/contra gearbox seems too be working satis. Is motor failure common? Was considering swapping the motors around? Any other fault finding or exploration you could recommend?

[Author]

Posts