Simannjo

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 9, 2006 at 8:11 am in reply to: Smeg not completing cycle – No error codes. #160183
    Simannjo
    Participant

    Re: Smeg not completing cycle – No error codes.

    Stripped door down to access control panel to check boards for wetness, dry joints etc and found nothing.
    Rebuilt and now all is OK – For the time being!!! 🙄

    January 8, 2006 at 11:05 am in reply to: Smeg not completing cycle – No error codes. #160182
    Simannjo
    Participant

    Re: Smeg not completing cycle – No error codes.

    Many thanks anyway… 😉

    January 8, 2006 at 9:27 am in reply to: Smeg not completing cycle – No error codes. #160180
    Simannjo
    Participant

    Re: Smeg not completing cycle – No error codes.

    Thanks for that Greg,

    Its a Type 11043 and the Model is DWD63SSE.
    I am assuming the drain pump is on the bottom right hand side front when facing the front of the dishwasher, attached directly to the sump, clipped in and held on with one screw!
    To test this would I have to watch for a supply voltage throughout a cycle and see the voltage continue when the pump stops?

    Hope this helps

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)