Forum Replies Created
-
Posts
-
Re: Beko DW686 problem
OK, I managed to enter into diagnostics mode finally. On this machine you only need to hold start button and then power up (no need to hold P button). After running diagnostic programs it leaked on P4 program and gave Er1 code. Anybody knows what this error code means?
Re: Beko DW686 problem
well, it is not working again. It was washing all night, showing about 0:45 left in the middle of the night which changed to 1:11 when I opened it in the morning… Does this indicate main board failure?
Re: Beko DW686 problem
I tried to run a test program by holding Program and Start buttons and powering it up. It shows IFT on the screen but if I press Start button it doesn’t do anything – only arrow sign comes on. Am I doing anything wrong?
Also checked flow meter and it seems to be fine. Checked wiring loom at the bottom edge of the door and can’t see any obvious damage to any of the wires.
And finally after assembling everything back it now runs normal. Not sure if this is for long though
