[smartypants]

Re: Whirlpool Dishwasher ADG957

Many thanks. There is no pattern to the flashing, it just keeps flashing…and flashing continuously! It doesn’t stop until I reset the machine by holding in the start button for several seconds.

[smartypants]

Re: Whirlpool Dishwasher ADG957

Thank you for your help regarding the dishwasher door – I wonder if you could help re another problem:

My integrated dishwasher keeps stopping towards the end of a cycle and beeping repeatedly (until I turn it off or reset). It seems to be during the rinsing or drying cycle (very hot and steamy when I open door) and always has half an inch of water in the bottom. There is also a metallic rattling noise from the base before it stops. If I switch it off for half an hour, I can then restart it and it will finish the cycle. Two local engineers (not Whirlpool specialists) have failed to find the cause. Would be VERY grateful for any suggestions! Thanks.

[smartypants]

Re: Whirlpool Dishwasher ADG957

Hi, thanks for that, have studied the door and can see the logic. Will try tomorrow as it’s a bit late now. Very grateful for your help. You are fantastic!! 😛 😆

[smartypants]

Penguin45 wrote:Are there not two plastic rails with “T” sections moulded to them attached to the door panel?

Penguin45.

Yes, there are….we have tried introducing the door panel back on, but it just falls off again.

[Author]

Posts