[speedy247]

Re: NEFF on/off light will not come on

I replaced the Control Panel Module and the buttons lit up as normal on the replacement part – good stuff!! I followed the reset procedure for the Control Panel Module and all was good. I then set the dishwasher to start. However a few minutes later I noticed that it wasn’t washing. I opened the door and the tap icon was lit up. I then remembered that I had not turned back on the water supply at the valve. I turned this on, but could still see the tap error light was on. I then did another Control Panel Module reset, but the tap error remains on. I the re-checked the valve inlet filter, and it was clean. Turned the valve back on again. I can feel the solenoid at the valve inlet buzzing but I don’t know why the water is still not coming in.
I have checked the float inside the dishwasher and it works. I put a few jugs of water into the dishwasher and turned it on, it drained the jugs of water. I checked the float underneath the dishwasher and it goes up and down and I can hear the float switch clicking as it turns on and off.
Is there a special way of re-setting the tap error light/icon on the Control Panel Module?

[speedy247]

Re: NEFF on/off light will not come on

Hi Martin, thanks for your reply. So you think it might be the Control Panel Module too? In that case I might as well go ahead and order the new module. Was there any other checks I should try out in order to confirm that it is the Control Panel Module itself that’s the issue?

[Author]

Posts