[stuartam]

Re: Hotpoint WD860 – F-04 error?

twinspark wrote:with machine upplugged check you have good connection in the pump two way plug and the same in the bottom 7 way plug on modual that harness does fail. one end goes into motor then twoo off to pump
then to modual

thanks just checked the connections all looks to be clean contacts etc, tried it again and the pump goes but after less than a minute i get the same f-04 error.

thanks

[stuartam]

Re: Hotpoint WD860 – F-04 error?

twinspark wrote:does the pump operate if you select spin???

just checked and set it to do a spin cycle and no the pump dosnt operate

thanks

[stuartam]

Re: Hotpoint WD860 – F-04 error?

gandh1 wrote:did you clean out further down the hose between the “tennis ball” and pump?

thanks for the reply, yea i have taken the hose complety off, taken apart the pump, and even checked the small pipe leading to the pressure sensor.

[stuartam]

Re: Hotpoint WD860 – F-04 error?

any ideas?

[Author]

Posts