Forum Replies Created
-
Posts
-
Re: Whirlpool DWF B10 Bleeping Problem..!
An update just in case anybody else has a similar problem : I purchased a new WI from this site which cured all my problems, and the machine has worked fine ever since. 😀
Re: Whirlpool DWF B10 Bleeping Problem..!
ok, the water tray was absolutetly full of water. I mopped it all up and started the cycle again. The leak is clearly coming from the water indicator thing that I took out and cleaned earlier (the black thing with the grill). I took it out again to see if I had punctured the membrane, but all looks well (I did have to scrape out the clogged up gunge though, so maybe I did puncture it and just can’t see it?). I’m pretty sure I put it back correctly as well, and I think it had been leaking before I took it out to clean, as the tray had water in it before I cleaned it first time.
Do I need a new water indicator? If so, can I get one through this site..?
Thanks for your assistance.
Re: Whirlpool DWF B10 Bleeping Problem..!
Thanks for that – I gave it a good clean – I even took it out (what fun that was), as I couldn’t really get to it to give it a good clean. I also cleared out the tray at the bottom as this had quite a lot of water in it.
It starts the cycle, but then there is a constant clicking noise (sounds like a relay or something) coming from the start button area. This went on for ages until I got fed up with it and reset the progam and started again. The clicking noise was then replaced by our old friend the bleeping noise (with the accompanying four flashes).
