[TD1947]

Re: 3 ENGINEERS LATER AND STILL NOT WORKING CAN ANYONE HELP

Hi, if this is a BEKO WMA1715S (or similar) – this electronic model sometimes needs RESETTING.

However, if this needs doing repeatedly, there is probably a fault that needs rectifying. However, many fault codes can be caused by objects sticking in the pump, or affecting the pump-out.

If you are sure there are no basic faults present, like a broken belt, worn motor brushes, jammed pump, something stuck in the outlet pipe, no fill (blocked inlet) , or blocked drain. Then try the reset below. You will need to do this reset once you fix any of the problems above anyway:

If the prewash light is flashing right hand side of machine:
Start by turning the power button on the machine to off (not at the wall)
Select the 90 degree wash
Hold the Start and Cancel button down at the same time for 3 seconds and turn power button ON whilst still holding buttons down –
Start light should flash.
Leave the power on.
Select any Spin position.
Press Start and Cancel button at the same time again for 3 seconds – other buttons may start to flash – if they do, press Start and Cancel button together again for 3 seconds.
Machine should be re-set ready for use. If there is STILL a flashing light after this, then you still have a fault that needs rectified.

[Author]

Posts